Configuring The Tcc - Thermo Scientific Dionex UltiMate 3000 Series Operating Instructions Manual

UltiMate 3000 Series:
TCC-3000SD and TCC-3000RS Column Compartments

3.5.3 Configuring the TCC

3.5.3.1 Initial Installation
During the installation, Chromeleon connects to the TCC and transfers the settings from the
instrument firmware to Chromeleon, setting the options on the wizard pages accordingly.
Verify that the standard settings are correct and make additional settings if needed. You may
reopen the configuration pages later again to change the settings (→ page 41).
Tip: Changing the settings for a specific application in the Commands dialog box,
in a program file (PGM), or on a control panel will not change the standard
settings on the configuration pages.
For additional information about a page, click Help.
General Page
The General page shows the general instrument parameters.
• Device Name displays the name used to identify the TCC in the installation environment
and in the Chromeleon Client program. To control the TCC with the existing control
panels, accept the default name. If you enter a different name, you may have to re-link
the controls on the control panels and edit the name of the TCC in the program files.
• Demo Mode
This check box should be cleared because Chromeleon only simulates the functions of
the TCC when the demo mode is active. If the Demo Mode is enabled, the Module
address box will be unavailable. If you exit this page without having entered a module
address, the Demo Mode will be enabled automatically.
Page 38
Fig. 10: General page
Operating Instructions