Thermo Scientific Dionex UltiMate 3000 Series Operating Instructions Manual page 59

3. If you want to use column identification
Attach the column ID chip card to the column (two chip cards are provided in the TCC
accessories kit). Wrap the ribbon around the column, pass the shank of the rivet through a
hole, and press down to unite the two parts.
4. Press the column into the bottom part of the clip and reinstall the ring.
5. Connect the capillaries to column. Observe the precautions on page 46.
6. Establish the fluid connections between the columns and the column switching valves.
For information about how to connect the capillaries to the valve, see section 4.8
(→ page 53).
7. Activate column identification if applicable (→ page 75).
Operating Instructions
TCC-3000SD and TCC-3000RS Column Compartments
Fig. 20: Attaching the column ID to the column
Fig. 21: Installing a column in the clip
UltiMate 3000 Series:
Page 51