Automated Control - Thermo Scientific Dionex UltiMate 3000 Series Operating Instructions Manual

5.3.3 Automated Control

With automated control, you create a program file (PGM) for automated operation of the
TCC. You can create programs automatically with the software wizard or manually by
editing an existing program. In addition to programs for sample analysis, you can also
create programs for special purposes, for example, to ensure that the system automatically
restarts operation as desired after a power failure or to automate system shutdown
(→ page 85). For details about these programs, see the Chromeleon Help.
To create a program with the Program Wizard
1. Open the Program Wizard. On the File menu, select New, and then select Program
File.
2. The wizard guides you through program creation. The wizard guides you through
program creation. For additional information about a page, click Help.
3. After you finish the wizard, Chromeleon automatically creates the program.
4. To start the program, follow the steps below (→ page 66).
To create a program manually
1. Open an existing program.
Select and double-click the program you want to open.
—or—
On the File menu, select Open. In the dialog box, select Program on the Object of Type
list and select the program.
Opens the
Commands View
Open the
Device Views
Fig. 34: Chromeleon program (here: program shown in the Commands view)
Operating Instructions
TCC-3000SD and TCC-3000RS Column Compartments
UltiMate 3000 Series:
Page 65