Status Screen - Thermo Scientific Dionex UltiMate 3000 Series Operating Instructions Manual

UltiMate 3000 Series:
TCC-3000SD and TCC-3000RS Column Compartments

5.2 Status Screen

When the self test was successful, the initial TCC screen changes to the status screen. The
TCC type determines the appearance of the screen.
Fig. 31 shows the status screen for instruments with column switching valves. For instruments
without column switching valves, the appearance of the screen is similar to status screen
shown in Fig. 42 (→ page 78).
Compartment
100.0
Post-Column Cooler: 10.0 °C (8.0 °C)
Fig. 31: Status screen (here TCC-3000RS with two 2-position, 10-port switching valves)
Under ...
Compartment
Switching Valves
Post-Column Cooler
(TCC-3000RS only)
You can adapt the screen brightness and contrast to your requirements if necessary
(→ page 78).
Page 60
Switching Valves
°C
105.0
The following information appears ...
Current column temperature (in °C)
Target temperature for column thermostatting (in °C)
The temperature value is flashing until the selected temperature is reached.
If column thermostatting is disabled, Off is displayed.
Flow path in the column switching valves (if installed).
Current temperature of the post-column cooler (in °C)
Temperature setpoint for post-column thermostatting (in °C)
The temperature value is flashing until the selected temperature is reached.
If post-column thermostatting is disabled, Off is displayed.
10-1 1-2
Operating Instructions