Operation Sound Setting; Changing The Time Until “Rest Reminder” Is Displayed; Changing The Turn Signal Sound - Mitsubishi MOTORS Outlander PHEV 2018 Owner's Manual

NOTE
• When "A or 1" (language cooperation:
enabled) has been selected, the language for
Multi Around Monitor (if so equipped) is
automatically changed to the language
selected for the multi-information display.
However, this changing function may not
work depending on the language selected
for the multi-information display.
• When "M, 2 or P" (language cooperation:
disabled) has been selected, the language
for Multi Around Monitor (if so equipped)
is not automatically changed to match the
language selected for the multi-informa-
tion display.
 The language on the audio system's display
does not automatically change when you
select A or 1 (language cooperation:
enabled) in the language cooperation control.

Operation sound setting

You can turn off the operation sounds of the
multi-information display switch and rheostat
illumination button.
1. Press and hold the multi-information dis-
play switch (for approximately 2 seconds
or more) to switch from the setting mode
screen to the menu screen.
Refer to "Changing the function settings"
on page 5-143.
2. Lightly press the multi-information dis-
play switch to select "
sound setting).
3. Press and hold the multi-information dis-
play switch (for approximately 2 seconds
or more) to switch from ON (operation
sound on) to OFF (operation sound off),
or from OFF to ON.
The setting is changed to the selected con-
dition.
NOTE
 If the 12 V starter battery is disconnected,
the memory of the operation sound setting is
erased and is automatically set to "ON"
(operation sound on).
 The operation sound setting only deactivates
the operation sound of the multi-information
display switch and rheostat illumination but-
ton. The warning display and other sounds
cannot be deactivated.
N00557401185
Changing the time until "REST
REMINDER" is displayed
The time until the display appears can be
changed.
1. Press and hold the multi-information dis-
play switch (for approximately 2 seconds
" (operation
or more) to switch from the setting mode
screen to the menu screen.
Refer to "Changing the function settings"
on page 5-143.
2. Lightly press the multi-information dis-
play switch to select "ALARM" (rest time
setting).
3. Press and hold the multi-information dis-
play switch (for approximately 2 seconds
or more) to display "ALARM" (rest time
setting).
4. Lightly press the multi-information dis-
play switch to select the time until the dis-
play appears.
5. Press and hold the multi-information dis-
play switch (for approximately 2 seconds
or more) to change the setting to the
selected time.
NOTE
 If the 12 V starter battery is disconnected,
the memory of the unit setting is erased and
is automatically set to the "OFF".
 The drive time is reset when the operation
N00557501199
mode is in OFF.

Changing the turn signal sound

It is possible to change the turn signal sound.
Features and controls
Multi-information display
N00563501110
5-147
5