Engine Coolant/Plug-In Hybrid Ev System Coolant; To Replace The Oil Filter; To Check The Coolant Level; To Add Coolant - Mitsubishi MOTORS Outlander PHEV 2018 Owner's Manual

Engine coolant/Plug-in Hybrid EV System coolant

To replace the oil filter

The oil filter should be replaced at the time or
mileage specified in the "WARRANTY AND
MAINTENANCE MANUAL".
Only use high quality replacement filters on
this vehicle. The manufacturer's specifica-
tions for Mitsubishi Motors Genuine oil fil-
ters require that the filter can withstand a
pressure of 256 psi (1.8 MPa). A Mitsubishi
Motors Genuine oil filter is the best replace-
ment filter.
Follow the installation instructions printed on
the filter.
9
9-8 Vehicle care and maintenance
Engine coolant/Plug-in
Hybrid EV System coolant

To check the coolant level

The engine coolant reservoir (A) and the
Plug-in Hybrid EV system coolant reservoir
(B) lets you quickly see when you need to
add coolant. When the engine and the Plug-in
Hybrid EV system are cold, the level of the
coolant in the reservoir should be between the
FULL and LOW marks. The radiator usually
stays full so there is no reason to remove the
radiator cap (C) except when you check the
coolant freeze point or replace the antifreeze
coolant.
N00937801666
FULL
LOW

To add coolant

Use "Mitsubishi Motors Genuine Super Long
Life Coolant Premium" or equivalent*.
*: similar high quality ethylene glycol based
non-silicate, non-amine, non-nitrate and
non-borate coolant with long life hybrid
organic acid technology
FULL
LOW