Mitsubishi MOTORS Outlander PHEV 2018 Owner's Manual page 82

Rear center seat
To reduce the risk of injury in an accident,
pull up the head restraint to the locked posi-
tion.
 To raise the restraint, pull it straight up.
 To lower the restraint, push down on it
while pressing the lock knob (A) in the
direction shown by the arrow.
 After adjusting the height, push down on
the restraint to make sure it is locked in
position.
WARNING
 When a person sits in the rear center seat-
ing position, pull up the head restraint to a
height at which it locks in position. Be
sure to make this adjustment before start-
ing to drive. Serious injuries could other-
wise be suffered in the result of an impact.
NOTE
 The head restraint height in the rear outboard
seats cannot be adjusted.
Head restraints
To remove
Press the lock knob (A) in the direction
shown by the arrows. Then pull the head
restraint up and out of the seatback.
WARNING
 To help minimize the risk of neck injury in
the event of an accident, the head
restraints must be properly installed and
positioned to proper height before vehicle
operation.
To install
First check that the head restraint is facing in
the right direction as shown in the previous
illustration, and then insert it into the seat-
back. Push the head restraint down while
Seat and restraint systems
4
4-11