Remote Control Transmitter Battery Replacement - Mitsubishi MOTORS Outlander PHEV 2018 Owner's Manual

NOTE
 If the UNLOCK button (2) is pressed when
all doors and the liftgate are locked and no
doors or the liftgate are opened within
approximately 30 seconds, the doors and the
liftgate will automatically re-lock.
On a vehicle equipped with the Smartphone
Link Display Audio, the functions can be
adjusted on the screen. For details, refer to
the separate owner's manual.
 If the following conditions are observed after
pressing the LOCK (1) or UNLOCK (2) but-
ton on the remote control transmitter, the
battery in the F.A.S.T.-key may need to be
replaced.
• The doors and the liftgate cannot be locked
or unlocked.
• The panic alarm cannot be operated.
• The indicator light (5) is dim or does not
come on.
 If you lose your F.A.S.T.-key, please contact
a certified Mitsubishi EV dealer for a
replacement.
 If you wish to obtain an additional F.A.S.T.-
key, please contact a certified Mitsubishi EV
dealer. A maximum of four F.A.S.T.-key can
be programmed for your vehicle.
 To use the new remote control transmitters, it
is necessary to register the key with both the
electronic immobilizer and keyless entry sys-
tem.
Also refer to "Electronic immobilizer (Anti-
theft starting system): Customer F.A.S.T.-
key programming" on page 5-17.
Free-hand Advanced Security Transmitter (F.A.S.T.-key)
General information
Your F.A.S.T.-key operates on a radio fre-
quency subject to Federal Communications
Commission (FCC) Rules (For vehicles sold
in U.S.A.) and Industry Canada Rules (For
vehicles sold in Canada). This device com-
plies with Part 15 of FCC Rules and Industry
Canada licence-exempt RSS standard(s).
Operation is subject to the following two con-
ditions.
•This device may not cause harmful
interference.
•This device must accept any interference
received, including interference that
may cause undesired operation.
CAUTION
 Changes or modifications not expressly
approved by the manufacturer for compli-
ance could void the user's authority to oper-
ate the equipment.
Procedure for replacing the
remote control transmitter bat-
N00562001062
tery
1. Before replacing the battery, remove static
electricity from your body by touching a
metal grounded object.
2. With the Mitsubishi mark facing you,
insert the cloth-covered tip of a flat blade
screwdriver into the notch in the case and
use it to open the case.
NOTE
 Be sure to perform the procedure with the
Mitsubishi mark facing you. If the Mitsubi-
shi mark is not facing you when you open the
case, the transmitter may come out.
3. Remove the old battery.
Features and controls
N00562101092
5
5-21