MITSUBISHI Remote Control (if so equipped)
NOTE
Wireless LAN devices may not communicate
with the vehicle, or may not operate nor-
mally or stably in the following environment
3
or situations. Check that the device can com-
municate with your vehicle before use.
• There is an obstruction such as a concrete
or metal wall between the vehicle and wire-
less LAN device.
• The vehicle is surrounded by tall vehicles
in a parking lot.
• There are facilities nearby that emit strong
radio waves, such as a TV tower, trans-
former substation, broadcasting station or
airport.
• There is a communication device such as a
mobile phone or radio, or an electric device
such as a personal computer near the wire-
less LAN device.
• The wireless LAN device is in contact with
or covered by a metal object.
• The battery of the wireless LAN device has
run down.
The MITSUBISHI Remote Control cannot
be used under the following conditions:
• The wireless LAN device is turned off.
• The MITSUBISHI Remote Control appli-
cation software is not installed.
• The MITSUBISHI Remote Control appli-
cation software is not running.
• The wireless LAN device is not registered
on the vehicle or it is not connected to the
vehicle.
3-44
General information/Charging
NOTE
• The wireless LAN device is out of the com-
munication range.
• The wireless LAN device is connected to
other wireless LAN device.
• The wireless LAN device has failed, or its
battery has run out.
Some charging facilities have a timer func-
tion that turns the power on or off at a spe-
cific time of the day. When charging at a
facility with a timer function, make sure that
the charging timer is set within the time
period when the power in the charging facil-
ity is on.
The 12 V starter battery is automatically and
periodically charged using electrical power
stored in the main drive lithium-ion battery.
A buzzer in cabin sounds while the auxiliary
battery is being charged.
While the remote climate control is operating
or the charging, the cooling fan or air condi-
tioner compressor may start operating and its
sound may be heard. But this is normal.
The remote climate control operates in its
own mode based on the mode selected on the
wireless LAN device, regardless of the
switch setting of the vehicle's air condi-
tioner.
Air conditioning performance may deterio-
rate or the remaining quantity of the main
drive lithium-ion battery may decrease under
the following conditions:
• In extremely hot weather.
• In hot sunshine.
NOTE
• In extremely cold weather.
If the remote climate control is started during
charging, the time until full charge may
extend or the charging rate may decrease.
When the remaining quantity of the main
drive lithium-ion battery is decreased, the
remote climate control does not operate or it
may stop on the way.
When the 12 V starter battery is removed,
the timer control of the MITSUBISHI
Remote Control is reset and each function of
the MITSUBISHI Remote Control cannot be
used. Also the main drive lithium-ion battery
cannot be warmed up.
Communicate the wireless LAN device and
your vehicle again.
General information
MODEL: K9499-002
FCC ID: RX8K9499-001
IC: 2795E-K9499001
This device complies with Part 15 of FCC
Rules and Industry Canada licence-exempt
RSS standard(s). Operation is subject to the
following two conditions:
(1) this device may not cause interference,
and
N01216600026