Table of Contents
Advertisement
120 V AC power supplies (if so equipped)
NOTE
12 V power outlets and 120 V AC power
supplies can be used simultaneously. Refer
to "12 V power outlets" on page 5-196.
If the plug of the electrical appliance was
loose or wobbled when inserted in the outlet,
replace the 120 V AC power supply by a cer-
5
tified Mitsubishi EV dealer.
Never leave the vehicle, perform refueling or
washing the vehicle while using the 120 V
AC power supply.
You may hear operating sounds such as
sounds from the cooling fan near luggage
area when using the 120 V AC power supply.
This is normal.
Never use electrical appliance which is vul-
nerable to vibration or heat in the cabin.
When exposed to the strong direct sunlight,
the cabin will become extremely hot. It could
cause product failure.
Do not use the 120 V AC power supply with
the vehicle covered by a car cover.
When closing the window, door or liftgate,
be careful not to trap the power supply cord
of the electrical appliance.
120 V AC power supply cannot be used in
the following cases.
• When Plug-in Hybrid EV System warning
light is illuminated.
• When the main drive lithium-ion battery
level display indicates 0.
• When the "PROPULSION POWER IS
REDUCED" warning display appears.
5-200
Features and controls
NOTE
Electrical appliance may not operate nor-
mally or electricity supply stops under the
following conditions. You may hear an oper-
ation noise. This is normal.
• When the power consumption of the electri-
cal appliance exceeds 1500 W.
• When the vehicle interior temperature is
too hot or too cold.
When the 120 V AC power supply cannot be
used or is not returned to operation automati-
cally after stopping electricity supply, follow
the procedures below.
1. Disconnect the plug of electrical appli-
ance.
2. Confirm the remaining quantity of the
main drive lithium-ion battery. When it is
low, charge the main drive lithium-ion
battery by using the battery charge mode
switch, etc.
"Battery charge mode switch" P.5-66
"Normal charging (charging method
with rated AC 120 V outlet)" P.3-20
"Quick charging (charging method
with quick charger)" P. 3-32
3. Confirm the ready indicator illuminates.
If not, start the Plug-in Hybrid EV Sys-
tem.
4. When the vehicle interior temperature is
too hot or too cold, adjust it appropriately
by using air conditioner.
5. Press the 120 V AC power supply switch
to turn on.
NOTE
6. Confirm the indicator light on 120 V AC
power supply switch comes on and insert
the plug in the power outlet.
The following electrical appliance may not
operate normally even if the power con-
sumption is less than 1500 W. Also be aware
that electric power which can be used will
vary depending on the main drive lithium-
ion battery condition.
• Electrical appliance to which large current
flows momentarily
• Electrical appliance which gauges precise
data
• Electrical appliance which does not operate
normally when it is not placed horizontally
• Electrical appliance which needs extremely
stable operation
• Electrical appliance with a timer function,
which needs the consecutive output
AC power output may be shut off and the
electrical appliance may be turned off
accordingly depending on the main drive
lithium-ion battery condition even if the bat-
tery level display does not indicate 0.
Use of electrical appliance could cause radio
or television noise.
The voltage of the 120 V AC power supply
cannot be correctly gauged with a commer-
cially available tester. Consult a certified
Mitsubishi EV dealer when you need mea-
surement of the voltage.
Also refer to the instruction manual and label
accompanying the electrical appliance.
Advertisement
Table of Contents
