Outside Rearview Mirrors - Mitsubishi MOTORS Outlander PHEV 2018 Owner's Manual

3. Press the switch (1) until the correct zone
number is found and release the switch.
The visual display will show a compass
direction within a few seconds.
CAUTION
 Adjust for compass variance when the vehi-
cle is safety parked.
NOTE
 The compass adjustment mode will automat-
ically shut off, if no adjustment is made
within approximately 10 seconds.
 If adjusting the zone setting did not correct
the compass heading error, or if the zone is
already properly set for your area, re-cali-
brate the compass according to the instruc-
tion.
Refer to "To re-calibrate the compass" on
page 5-49.
 To re-calibrate the compass
1. Press the switch (1) for approximately 10
seconds until the "C" is displayed in the
visual display.
2. Drive the vehicle in a circle at approxi-
mately 5 mph (8 km/h) or less until the
direction is displayed in the visual display.

Outside rearview mirrors

Adjust the outside rearview mirrors only after
making any seat adjustments so as to have a
clear view to the rear of the vehicle.
Outside rearview mirrors
WARNING
N00589700025
 Do not attempt to adjust the outside rear-
view mirrors while driving. This can be
dangerous.
Be sure to adjust the mirrors before driv-
ing.
 Your passenger's side mirror is convex.
The objects you see in the mirror will look
smaller and farther away than they
appear in a regular flat mirror.
Do not use this mirror to estimate the dis-
tance of vehicles following you when
changing lanes.
N00512201232
Features and controls
5
5-49