Handling Of The Sensor - Mitsubishi MOTORS Outlander PHEV 2018 Owner's Manual

If the FCM detects a malfunction in the sys-
tem, either of the following messages will
appear, the indicator will appear on the
information screen of the multi-information
display and the FCM will automatically be
turned off.
If the message remains even after the opera-
tion mode of the power switch is put in OFF
and then turned back to ON, please contact a
certified Mitsubishi EV dealer.
Forward Collision Mitigation System (FCM) (if so equipped)
NOTE
 If the sensor or its surrounding area becomes
extremely high temperature when parking
the vehicle under a blazing sun, the "FCM
SERVICE REQUIRED" message
appear.
After the temperature of the sensor or its sur-
rounding area has been in range, if the mes-
sage remains even after restarting the Plug-in
hybrid EV system, please contact a certified
Mitsubishi EV dealer.

Handling of the sensor

The sensor (A) is located inside the wind-
shield as shown in the illustration.
may
The sensor is shared in the following sys-
tems:
 FCM
 Lane Departure Warning (LDW)
 Automatic High Beam (AHB)
CAUTION
 To maintain proper performance of the FCM,
LDW and AHB;
• Always keep clean the windshield.
If the inside of the windshield where the
sensor is installed becomes dirty or fogged,
contact a certified Mitsubishi EV dealer.
• Do not apply an impact or load on the sen-
sor or its surrounding area.
Features and controls
N00593400078
5
5-101