Mitsubishi Remote Control (If So Equipped) - Mitsubishi MOTORS Outlander PHEV 2018 Owner's Manual

Table of Contents

Advertisement

MITSUBISHI Remote Control (if so equipped)

MITSUBISHI Remote Con-
trol
(if so equipped)
3
The MITSUBISHI Remote Control allows
you to operate the vehicle within the commu-
nication range of the wireless LAN device
(which conforms to IEEE 802.11b and sup-
ports iOS or Android). The following opera-
tions are available.
NOTE
 The communication distance differs depend-
ing on the wireless LAN device, due to this
the communication may go down.
1- Wireless LAN device
2- Antenna
3-42
General information/Charging
 Charging timer
If you specify the charge start and/or stop
time with the normal charge cable con-
nected, charging is started and/or stopped
N01216300036
at that time.
 Remote climate control
By setting the remote climate control to
operate at a predetermined time, cabin
comfort can be improved or visibility can
be ensured (defrosting/demisting) before
getting on the vehicle.
 Customize (function setting change)
The function setting of the F.A.S.T.-key,
outside rear-view mirror, operation mode
of the power switch, air conditioning,
lights and windshield wipers can be
changed by MITSUBISHI Remote Con-
trol.
NOTE
 In a vehicle equipped with the Smartphone
Link Display Audio, it is possible to change
the setting by means of screen operations.
Refer to the separate owner's manual for
details.
NOTE
 If you want to cancel the charging timer in
cases of the battery exhaustion or loss of a
wireless LAN device, you can temporary
cancel the charging timer by pressing the
F.A.S.T.-key of the switch (A) twice within 2
seconds. When the charging timer is can-
celed, the hazard warning lights will blink
four times.
 When using the charging timer, use the EV
charging cable.
If using a home or public charging device
(EVSE: Electric Vehicles Supply Equip-
ment), the charging timer may not be started.
Devices that support wireless LAN are
required to communicate with the vehicle
using the MITSUBISHI Remote Control.
Also, an SSID* (A) and password (B) are
required to connect a wireless LAN device to
the vehicle. The SSID and password are
described in the registration information card
(C) that is attached to the key at the time of
your purchase of the vehicle.

Advertisement

Table of Contents
loading

Table of Contents