Coming Home Light; Headlight Leveling Switch (If So Equipped) - Mitsubishi MOTORS Outlander PHEV 2018 Owner's Manual

Headlight leveling switch (if so equipped)

Coming home light

This function turns on the headlights in the
low beam setting for approximately 30 sec-
onds after the operation mode is put in OFF.
1. Turn the combination headlights and dim-
5
mer switch to the "OFF" or "AUTO"
position.
2. Put the operation mode in OFF.
3. Within 60 seconds of putting the opera-
tion mode in OFF, pull the turn signal
lever toward you.
5-184 Features and controls
4. The headlights will come on in the low
beam setting for approximately 30 sec-
N00547301208
onds. After the headlights go off, the
headlights can be turned on again in the
low beam setting for approximately 30
seconds by pulling the turn signal lever
toward you within 60 seconds of putting
the operation mode in OFF. To turn on the
headlights again after 60 seconds of put-
ting the operation mode in OFF, repeat the
process from step 1.
NOTE
 While the coming home light function is
operating, perform one of the following
operations to cancel the function.
• Pull the turn signal lever toward you.
• Turn the combination headlights and dim-
mer switch to the "
or put the operation mode in ON.
• Put the operation mode in ON.
 It is possible to modify functions as follows:
• The time that the headlights remain on can
be changed.
• The coming home light function can be
deactivated.
For details, consult a certified Mitsubishi EV
dealer.
On vehicles equipped with the Smartphone
Link Display Audio, screen operations can
be used to make the adjustment.
Refer to separate owner's manual for details.
Headlight leveling switch
so equipped)
The direction of the headlight beam (the
direction in which the light shines) alters
according to the number of people and the
load in the vehicle. Lower the headlight angle
if it is too high due to the number of people
and/or the load in the vehicle so that the head-
lights' glare does not distract the drivers of
approaching vehicles. First set the light
switch to the "
headlight leveling switch knob to lower the
beam. The greater the number on the head-
light leveling switch knob, the lower the
beam will point.
Set the switch to the appropriate position so
" or " " position
that the headlight beam is level with the road.
(if
N00537101128
" position, then turn the