Back-Up Lights - Mitsubishi MOTORS Outlander PHEV 2018 Owner's Manual

Replacement of light bulbs
3. Turn the socket counterclockwise and
remove it, and then pull the bulb out of
the socket.
D- Rear turn signal light
9
E- Tail light and stop light (LED) - cannot
be replaced
NOTE
 The rear side-marker light, tail light and stop
light use an LED instead of the bulb.
Check with a certified Mitsubishi EV dealer
when the light needs to be repaired or
replaced.
4. To install the bulb, perform the removal
steps in reverse.
9-36 Vehicle care and maintenance
NOTE
 When mounting the light unit, align the
notch (F) and pin (G) on the light unit with
the clip (H) and hole (I) in the body.

Back-up lights

1. Push the light unit upward to remove it.
NOTE
 Wrap a cloth around the tip of the screw-
driver to keep from scratching the lens.
2. Turn the socket (A) counterclockwise to
remove it, and then pull the bulb out of
the socket.
3. To install the bulb, perform the removal
steps in reverse.
N00929101080
NOTE
 When installing the light unit, first insert the
notch (B) into the hole on the body, and then
push on the light unit to fit it into place.