Table of Contents
Advertisement
EV charging cable
WARNING
Improper use of the EV charging cable
can result in a fire, property damage, and
serious injury or death.
3
Carefully read instructions regarding
"Precautions during Charging the Main
Drive Lithium-ion Battery" on page 3-19
and on "Normal charging (charging
method with rated AC 120 V outlet)" on
page 3-20 and described in this section
and follow them.
Always use an outlet protected by a
ground-fault circuit interrupter, rated for
15 A or more, and that is connected to a
dedicated branch circuit.
Never use an extension cable or conver-
sion adapter.
When using a non-waterproof outlet, take
care to avoid contact with rainwater dur-
ing charging.
Never connect or disconnect the plug with
a wet hand.
Make sure that the plug is inserted all the
way into the socket before use. Continued
charging with a plug not completely
inserted or pulled halfway out of the
socket may result in a risk of overheating
or fire.
If the indictors show the EV charging
cable malfunctions as described below,
stop using the EV charging cable and con-
tact a certified Mitsubishi EV dealer.
Never disassemble the EV charging cable
or attempt to open the control box.
3-30
General information/Charging
NOTE
All indicators are illuminated momentarily
for confirming operation when the EV charg-
ing cable plug is inserted into an outlet. After
that, the POWER indicator is continuously
illuminated and the CHARGING indicator is
continuously blinking.
The CHARGING indicator will start to blink
when charging is completed. The POWER
indicator is continuously illuminated while
EV charging cable plug is inserted into an
outlet.
Handling and storing the con-
trol box
CAUTION
Use the method shown below to help secure
the control box and to prevent the plug from
being pulled halfway out of the socket during
charging.
NOTE
Use hook (A) and a rope (B) that can support
the weight of the EV charging cable, 8.8 lbs
(4 kg) as shown in the figure below.
NOTE
Make sure that the rope has no damage
before use.
FCC Notice: This equipment has been tested
and found to comply with the limits for a
Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to
provide reasonable protection against harmful
N01202901054
interference in a residential installation.
This equipment generates, uses and can radi-
ate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interfer-
ence will not occur in a particular installation.
If this equipment does cause harmful interfer-
ence to radio or television reception, which
can be determined by turning the equipment
off and on, the user is encouraged to try to
correct the interference by one or more of the
following measures:
Advertisement
Table of Contents
