Whenever The Tires And Wheels Are Replaced With New Ones; Tire Id Set Change - Mitsubishi MOTORS Outlander PHEV 2018 Owner's Manual

Tire pressure monitoring system (TPMS)
The TPMS may not work normally in the fol-
lowing circumstances:
 A wireless facility or device using the
same frequency is near the vehicle.
 Snow or ice is stuck inside the fenders
and/or on the wheels.
 The tire inflation pressure sensor's battery
5
is dead.
 Wheels other than Mitsubishi Motors
Genuine wheels are being used.
 Wheels that are not fitted with tire infla-
tion pressure sensors are being used.
 Wheels whose ID codes are not memo-
rized by the vehicle are used.
 A window tint that affects the radio wave
signals is installed.
NOTE
 Tire inflation pressures vary with the ambi-
ent temperature. If the vehicle is subjected to
large variations in ambient temperature, the
tire inflation pressures may be under-inflated
(causing the warning light / display come on)
when the ambient temperature is relatively
low. If the warning light / display comes on,
adjust the tire inflation pressure.
5-116 Features and controls
Whenever the tires and wheels
are replaced with new ones
If new wheels with new tire inflation pressure
sensors are installed, their ID codes must be
programmed into the TPMS. Have tire and
wheel replacement performed by a certified
Mitsubishi EV dealer to avoid the risk of
damaging the tire inflation pressure sensors.
If the wheel replacement is not done by a cer-
tified Mitsubishi EV dealer, it is not covered
by your warranty.
CAUTION
 The use of non-genuine wheels will prevent
the proper fit of the tire inflation pressure
sensors, resulting air leakage or damage of
the sensors.

Tire ID set change

In case that 2 sets of tire inflation pressure
sensor ID are registered in the receiver, the
valid tire ID set can be changed by following
procedure.
1. Operate the multi-information display
switch to switch the information screen to
the menu screen.
Refer to "Multi-information
switch" on page 5-132.
Refer to "Changing the function settings"
on page 5-143.
N00532901219
2. Lightly press the multi-information dis-
play switch to select "
ID set change).
3. Hold down the multi-information display
switch for approximately 3 seconds or
more. The setting changes to the selected
tire ID set.
4. The valid tire ID set is changed, and the
N00584300055
number of the TPMS SET indicator is
changed.
NOTE
 Each time this procedure is done, the tire ID
set is changed. (1 - 2 - 1 - 2 ...)
 The tire ID set is NOT changed, in case that
only 1 set of ID is registered.
display
" (tire