Operating The Air Conditioning System - Mitsubishi MOTORS Outlander PHEV 2018 Owner's Manual

Table of Contents

Advertisement

Dual-zone automatic climate control air conditioner
Operating the air conditioning
system (automatic mode)
7
In normal conditions, use the system in the
AUTO mode and follow these procedures:
1. Press the AUTO switch.
2. Set the temperature control switch to the
desired temperature. The temperature can
be set within a range of around 61 (LO) to
89 (HI) (when the outside temperature
unit of the multi-information display
shows °F) or 17 (LO) to 31 (HI) (when the
outside temperature unit of the multi-
information display shows °C).
The vents, recirculation/outside air, blower
speed, temperature adjustment, and ON/OFF
of air conditioner will be controlled automati-
cally.
7-12
Comfort controls
NOTE
 Set the temperature at approximately 75
(when the outside temperature unit of the
N00731701472
multi-information display shows °F) or 24
(when the outside temperature unit of the
multi-information display shows °C) under
normal conditions.
 When the engine coolant temperature is low,
the air temperature from the heater will not
change instantly, even if you have selected
warm air with the temperature switch. To
prevent the windshield and windows from
fogging up, the vent mode will be changed to
"
" and the blower speed will be reduced.
Operating the air conditioning
system (manual mode)
Blower speed and vent mode may be con-
trolled manually by setting the blower speed
selection switch and the MODE switch to the
desired positions. To return to automatic
operation, press the AUTO switch.
Defrosting or defogging (wind-
shield, door windows)
CAUTION
 For safety, make sure you have a clear view
through all the windows.
To remove frost or mist from the windshield
and door windows, use the MODE switch or
defogger switch ("
 For ordinary defrosting
Use this setting to keep the windshield and
door windows clear of mist, and to keep the
leg area heated (when driving in rain or
snow).
N00731801125
1. Set the air selection switch to the outside
position.
2. Set the MODE switch to the "
tion.
3. Select your desired blower speed by
pressing the blower speed selection
switch.
N00732401519
4. Select your desired temperature by press-
ing the temperature control switch.
5. Press the air conditioning switch.
" or "
").
" posi-

Advertisement

Table of Contents
loading

Table of Contents