Average Fuel Consumption Display; Evhv Driving Rate Display - Mitsubishi MOTORS Outlander PHEV 2018 Owner's Manual

Table of Contents

Advertisement

NOTE
 When the main drive lithium-ion battery is
charged or the vehicle is refueled, the cruis-
ing range display is updated. However, if the
charge level is low or the refueling amount is
small, it cannot be updated correctly. Fully
charge the main drive lithium-ion battery or
refill to full tank whenever possible.
 On rare occasions, the value displayed for
the driving range may change if you are
parked on an extremely steep incline. This is
due to the movement of fuel in the tank and
does not indicate any malfunction.
 The display setting can be changed to the
preferred units (miles or km).
Refer to "Changing the function settings" on
page 5-143.
 When the EV cruising range falls below
approximately 1 mile (1 km), the EV cruis-
ing range display shows "---".
 When the total cruising range falls below
approximately 30 miles (50 km), the total
cruising range display shows "---".
 When the EV cruising range and total cruis-
ing range cannot be accurately measured
because there is some fault in the vehicle,
these display shows "---".
Average fuel consumption dis-
play
This displays the average fuel consumption
from the last reset to the present.
There are 2 types of mode settings of manual
reset and automatic reset.
Refer to "Changing the reset mode for aver-
age fuel consumption" on page 5-144.
For information on how to change the aver-
age fuel consumption display setting, refer to
"Changing the function settings" on page
5-143.
NOTE
 The average fuel consumption display can be
reset separately in both auto reset mode and
manual reset mode.
 "---" is displayed when the average fuel con-
sumption cannot be measured.
 The initial (default) setting is "Auto reset
mode".
 Average fuel consumption may vary depend-
ing on the driving conditions (road condi-
tions, how you drive, etc.) The actual fuel
consumption may differ from the fuel con-
sumption displayed, so treat the fuel con-
sumption displayed as just a rough guideline.
 Disconnecting the 12 V starter battery cable
will erase from memory the manual reset
mode or auto reset mode setting for the aver-
age fuel consumption display.
 The display setting can be changed to the
preferred units {mpg (US), mpg (UK),
L/100km or km/L}.
Refer to "Changing the function settings" on
N00575301043
page 5-143.
Multi-information display

EVHV driving rate display

This displays the ratios of the time traveled
with electric power and the time traveled with
both electric power and engine power.
The ratio of the time traveled with electric
power is displayed with a bar graph (blue)
and in a percentage.
NOTE
 When the main drive lithium-ion battery is
fully charged, EVHV driving rate is reset
and display becomes 100 %.
Features and controls
N00588500026
5
5-141

Advertisement

Table of Contents
loading

Table of Contents