Table of Contents
Advertisement
NOTE
Some devices may require you to replace this
"Programming a new HomeLink
with procedures noted in the "Gate operator /
Canadian programming" section. If the indi-
cator light does not change to rapidly flash-
ing green or continuously lit green after
performing these steps, contact HomeLink
at www.homelink.com
®
4. Press the HomeLink
button that was just
programmed and observe the indicator
light.
• If the indicator light continuously illumi-
nates green, programming is complete
and your device should operate when the
®
HomeLink
button is pressed and
released.
• If the indicator light rapidly flashes
green, firmly press, hold for 2 seconds
and release the programmed HomeLink
button. Repeat the "press/hold/release"
sequence a second time, and, depending
on the brand of the garage door opener
(or other rolling code equipped device),
repeat this sequence a third time to com-
plete the programming process. At this
point if your device operates, program-
ming is complete.
• If the device does not operate, continue
with "Programming a new HomeLink
steps 5 to 7 to complete the program-
®
" step 3
ming of a rolling code equipped device.
5. At the garage door opener receiver
(motor-head unit) in the garage, locate the
"Learn" or "Smart" button. This can usu-
ally be found where the hanging antenna
®
wire is attached to the motor-head unit
(see the garage door opener manual to
identify the "Learn" button.)
6. Firmly press and release the "Learn" or
"Smart" button. (The name and color of
the button may vary by manufacturer.)
There are typically 30 seconds to initiate
step 7.
7. Return to the vehicle and firmly press,
hold for 2 seconds and release the pro-
grammed HomeLink
"press/hold/release" sequence a second
time, and, depending on the brand of the
®
garage door opener (or other rolling code
equipped device), repeat this sequence a
third time to complete the programming
process.
®
HomeLink
should now activate your
rolling code equipped device.
HomeLink® Wireless Control System (if so equipped)
NOTE
®
"
In the event that there are still programming
difficulties or questions, additional Home-
Link
can be found online at www.homelink.com,
www.youtube.com/HomeLinkGentex, or by
calling the HomeLink
Gate operator/Canadian pro-
gramming
Canadian radio-frequency laws require trans-
mitter signals to "time-out" (or quit) after
several seconds of transmission - which may
not be long enough for HomeLink
up the signal during programming. Similar to
®
button. Repeat the
this Canadian law, some U.S. gate operators
are designed to "time-out" in the same man-
ner.
The indicator LED on the hand-held transmit-
ter will go off when the device times out indi-
cating that it has finished transmitting.
If you live in Canada or you are having diffi-
culties programming a gate operator or
garage door opener by using the "Program-
ming" procedures, replace "Programming a
new HomeLink
®
information and programming videos
®
Hotline.
N00584800021
®
to pick
®
" step 3 with the following:
Features and controls
5-203
5
Advertisement
Table of Contents
