Mitsubishi MOTORS Outlander PHEV 2018 Owner's Manual page 283

Indicator light, warning light, and information screen display list
Screen
5
5-162 Features and controls
Cause
 The brake auto hold system does not turn on because
the driver's seat belt is not fastened.
 The brake auto hold system does not turn off because
the brake pedal is not pressed.
 There is a fault in the engine oil circulation system.
 There is a fault in the SRS airbag or the pre-tensioner
system.
 There is a fault in the Active stability control (ASC).
 There is a fault in the Hill start assist.
Do this (Reference)
 Press the brake auto hold switch after fastening the
driver's seat belt.
Refer to "Brake auto hold" on page 5-69.
 Depress the brake pedal more firmly than usual with
the right foot. Then, press the brake auto hold switch.
Refer to "Brake auto hold" on page 5-69.
 Park your vehicle in a safe place as soon as possible
and contact a certified Mitsubishi EV dealer to have
the system checked.
Refer to "Oil pressure warning display" on page
5-177.
 Contact a certified Mitsubishi EV dealer to have the
system checked, immediately.
Refer to "SRS warning light/display" on page 4-39.
 Contact a certified Mitsubishi EV dealer to have the
system checked.
Refer to "Active stability control (ASC)" on page
5-76.
 Have the vehicle checked at a certified Mitsubishi
EV dealer.
Refer to "Hill start assist" on page 5-71.