Air Selection Switch - Mitsubishi MOTORS Outlander PHEV 2018 Owner's Manual

Air selection switch

Normally, use the outside air position to keep
the windshield and side windows clear and to
quickly remove fog or frost from the wind-
shield.
To change the air selection, simply press the
air selection switch.
 Outside air {Indicator light (A) OFF}
Outside air is introduced into the passen-
ger compartment.
 Recirculated air {Indicator light (A) ON}
Air is recirculated inside the passenger
compartment.
When the air conditioning turns on, the air
selection is controlled automatically. When
the air conditioning turns off, the air selection
automatically goes back to the outside posi-
tion.
N00737201381
If high cooling performance is desired, or if
the outside air is dusty or contaminated in
some way, use the recirculation position.
Switch to the outside position every now and
then to keep the windows from fogging up.
CAUTION
 Using recirculated air for a long time may
cause the windows to fog up.
NOTE
 If the mode selection is set "
you cannot turn the air conditioner off or
select the recirculation position.
This prevents the windows from fogging up.
 When the engine coolant temperature rises to
a certain level, the air selection is automati-
cally switched to the recirculation position
and the indicator light (A) comes on. At this
time, the system will not switch to the out-
side position even if the air selection switch
is pressed.
 When the outside air temperature is high, the
system will not switch to the outside position
even the air selection switch is pressed if the
air conditioner is operating. This is to protect
the air conditioner compressor and is not a
failure.
Dual-zone automatic climate control air conditioner
 Personalizing the air selection
(Changing the function setting)
You can change the following functions to
match your preference.
 Enable automatic air selection control:
When the AUTO switch is pressed, the air
selection switch will also be automatically
controlled.
 Disable automatic air selection control:
Even when the AUTO switch is pressed,
the air selection switch will not be auto-
matically controlled.
" position,
 Changing the settings
Press the air selection switch for approxi-
mately 10 seconds or longer.
When the setting has changed, the system
will beep and the indicator light will flash.
• When the setting has changed from
enabled to disabled, the system will beep
three times and the indicator light will
flash three times.
• When the setting has changed from dis-
abled to enabled, the system will beep
two times and the indicator light will
flash three times.
Comfort controls
N00712300078
7
7-9