Table of Contents
Advertisement
To open
Press the switch (1), the sunroof automati-
cally opens.
To stop the moving sunroof, press the switch.
NOTE
The sunroof stops just before reaching the
fully open position. If the vehicle is driven
with the sunroof in this position, wind buf-
feting is lower than with the sunroof fully
open.
To close
Press the switch (3), the sunroof automati-
cally closes.
To stop the moving sunroof, press the switch.
To tilt up
When the switch (2) is pressed, the rear of the
sunroof raises for ventilation.
To tilt down
Press the switch (3).
NOTE
Be sure to tilt down the sunroof before clos-
ing the sunshade.
Sunroof timer function
The sunroof can be operated when the opera-
tion mode is in ON. The sunroof can be
opened or closed for a 30- second period after
the Plug-in Hybrid EV System is stopped.
However, when the driver's door or the front
passenger door is opened, the sunroof cannot
be operated. Start the Plug-in Hybrid EV Sys-
tem again to operate.
Safety mechanism
If a hand or head is trapped in the closing
sunroof opening, the safety mechanism will
cause the sunroof to re-open automatically.
The opened sunroof will become operational
again after a few seconds.
CAUTION
The safety mechanism is deactivated while
the switch (2) is pressed. Therefore be espe-
cially careful that fingers are not trapped in
the sunroof opening.
Sunroof (if so equipped)
CAUTION
Do not deliberately trap your hands or head
in order to activate the safety mechanism.
Personal injury and malfunction of the sun-
roof could result.
NOTE
The safety mechanism can be activated if the
driving conditions or other circumstances
cause the sunroof to be subjected to a physi-
cal shock similar to that caused by a trapped
hand or head.
If the safety mechanism is activated 5 or
more times consecutively, normal closing of
the sunroof will be aborted.
As an emergency measure, the sunroof can be
closed bit by bit until the sunroof is com-
pletely closed by repeatedly pressing the
switch (2).
After that, the sunroof can be set the initial-
ized state in the following procedure.
1. Move the sunroof in slide open position.
2. Press the tilt up switch (2) continually in
10 seconds.
3. The sunroof will be moved to tilt up posi-
tion automatically bit by bit.
4. The initialize is completed when the sun-
roof is stopped at tilt up position.
Features and controls
5
5-41
Advertisement
Table of Contents
