Rear-View Camera (If So Equipped) - Mitsubishi MOTORS Outlander PHEV 2018 Owner's Manual

General information
Your TPMS operates on a radio frequency
subject to Federal Communications Commis-
sion (FCC) Rules (For vehicles sold in
U.S.A.) and Industry Canada Rules (For vehi-
cles sold in Canada). This device complies
with part 15 of FCC Rules and Industry Can-
ada licence-exempt RSS standard(s).
Operation is subject to the following two con-
ditions.
 This device may not cause harmful inter-
ference.
 This device must accept any interference
received, including interference that may
cause undesired operation.
CAUTION
 Changes or modifications not expressly
approved by the manufacturer for compli-
ance could void the user's authority to oper-
ate the equipment.
Rear-view camera
(if so
equipped)
When the select position is in the "R"
(REVERSE) position with the operation
mode of the power switch in ON, the rear-
view image will be displayed on the screen of
N00533001262
the Smartphone Link Display Audio.
When the select position is shifted out of the
"R" (REVERSE) position, the rear-view
image will go off.
WARNING
 Never rely solely on the rear-view camera
to clear the area behind your vehicle.
Always check visually behind and all
around your vehicle for persons, animals,
obstructions or other vehicles. Failure to
do so can result in vehicle damage, serious
injury or death.
 The rear-view camera is an aid system for
backing up, but it is not a substitute for
your visual confirmation.
 The view on the screen is limited, and
objects outside the view, such as under the
bumper or around either corner of the
bumper end, cannot be seen on the screen.
N00546201356

Rear-view camera (if so equipped)

Location of rear-view camera
The rear-view camera (A) is in the liftgate, at
the left side of the liftgate handle.
CAUTION
 If the camera lens gets dirty, a clear image
cannot be obtained. As necessary, rinse the
lens with clean water and gently wipe with a
clean, soft cloth.
 To avoid damaging the camera;
• Do not rub the cover excessively or polish
it by using an abrasive compound.
• Do not disassemble the camera.
• Do not splash hot water directly on the lens.
• Do not spray the camera and its surround-
ings with high-pressure water.
• Make sure that the liftgate is securely
closed when backing up.
Features and controls
5
5-117