Waste Toner Box Holder; Before Removing The Collecting Toner Bottle Holder; Removing The Collecting Toner Bottle Holder - Canon imageRUNNER 5065 series Service Manual

Chapter 5
[A]
[B]
3) Fit the pins of the mirror positioning tool (front [2]; rear [3]) into the
appropriate holes [1] of the No. 1/No. 2 mirror base.
5-28
[C]
[B]
[A]
F-5-104
[1]
F-5-105
4) Secure the end of the cable that has temporarily been fixed in place on the
hook of the reader unit frame.
5) Fully tighten the screws on the cable fixing plate both at the front and the
rear.
6) Detach the mirror positioning tool (FRONT, REAR).
7) Put the detached parts back on by reversing the foregoing steps.

5.4.14 Waste Toner Box Holder

5.4.14.1 Before Removing the Collecting Toner Bottle
Holder
iR5065 / iR 5055 / iR5075 / / /
1) Remove the charger unit (this step is necessary only for iR5075 for Japan).
(page 10-20)Reference[Removing the Charger unit]
2) Remove the rear cover (upper). (page 10-11)Reference[Removing the
Rear Cover (Upper)]
3) Detach the rear cover (lower). (page 10-11)Reference[Removing the
Rear Cover (Lower)]
4) Detach the right cover (lower rear). (page 10-10)Reference[Removing
the Right Cover (Lower Rear)]

5.4.14.2 Removing the Collecting Toner Bottle Holder

iR5065 / iR 5055 / iR5075 / / /
1) Remove the collecting toner bottle.
2) Move the main power switch base [3] to the side.
- 2 Screw [1]
- 2 Wire saddle [2] (to free the harness)
[1]
3) Detach the connector base [3].
- 5 Connector [1]
- 2 Screw [2]
[3]
[2]
F-5-106
[2]
[3] [1]
F-5-107
0015-9424
0015-9425