Attaching Deck Pressure Plate; Setting Toner Container; Connecting The Cable - Canon imageRUNNER 5065 series Service Manual

Chapter 2
2) Slide the right deck and Cassett3/4 halfway out, and open the lower right
cover. Then, remove the pickup roller pressure release spacers [1].
MEMO;
The spacers are being pressured while the deck/cassette is set; thus, it is
hard to remove them.
Therefore, release the pressure by sliding the deck/cassette halfway out.
3) After removing all spacers, slide the deck/cassette in and close the lower
right cover.
4) Attach the door tape of the upper right cover with the screw, and close the
upper right cover.

2.2.8 Attaching Deck Pressure Plate

iR5065 / iR 5055 / iR5075 / / /
1) Press the release button of the left deck and slide the left deck out.
2) Attach the deck pressure plate [1] with the screw (RS tightening; M4X8)
[2].
[1]
3) Close the left deck.

2.2.9 Setting Toner Container

iR5065 / iR 5055 / iR5075 / / /
Do not shake the toner container.
If setting the toner container that has been shaken to the host machine, the
toner overflow within the machine may occur.
By shaking the container, the toner fluidity increases. As a result, toner is
supplied swiftly to the machine with the toner supply operation, causing the
foregoing symptoms.
1) Take out the toner container from the packing box.
2) After opening the toner replacement cover [1], pull down the lock lever
[2] in the direction of the arrow.
2-10
[1]
F-2-32
[1]
F-2-33
[2]
F-2-34
3) Hold the toner container [1] as shown in the figure below, and remove the
cap [2] from the container by rotating the cap in the direction of the arrow.
4) Hold the toner container with its mouth [1] at the right side, and set it into
the supply case [2] of the host machine horizontally.
0015-4663
5) Slide the lock lever [1] upward to lock the toner container [2] in place.
6) Close the toner replacement cover.
0015-4664
When turning on the main power switch without setting toner container, the
toner level meter on the control panel shows 25 % or less. Make sure that the
toner container is set in the host machine before turning on the main power
switch.

2.2.10 Connecting the Cable

iR5065 / iR 5055 / iR5075 / / /
1) Attach the wire saddle [1] onto the upper rear cover.
[1] [2]
F-2-35
[2]
[1]
F-2-36
[2]
[1]
F-2-37
[1]
[2]
F-2-38
0015-4665