Installing The Original Holder; Checking Contents; Installation Procedure - Canon imageRUNNER 5065 series Service Manual

Chapter 2
1) Check to see that 'ID00000001 to ID00001000' has been created in
Totals]. (In the case that '1' has been input as the first number by the service mode; COPIER > FUNCTION > INSTALL > CARD)
2) Press the reset key to escape the user mode screen.
3) Select > [System Settings] > [Network Settings] > [TCP/IP Settings] > [IP Address Settings], and then make the setting of [IP Address], [Gateway Address],
[Subnet Mask] according to the user environment
4) Press the reset key to escape the user mode screen.
5) Operate the touch panel following the instruction on the screen of shutdown sequence in order to turn off the main power switch.
6) Turn on the main power switch.
7)
> [System Settings] > [System Maneger Settings], and then input any number into [System Maneger ID] and [System Password].
8) Press the reset key to escape the user mode screen.
9) Turn off the power according to the shutdown sequence.

2.6 Installing the Original Holder

2.6.1 Checking Contents

iR5065 / iR 5055 / iR5075 / / /
Document Tray-K1

2.6.2 Installation Procedure

iR5065 / iR 5055 / iR5075 / / /
1) Tighten the 2 stepped screws (M4X33) [1] to the upper cover (right).
2) Hook the document tray [1] to the stepped screws tightened in the step 1.
2-22
> [System Settings] > [Dep ID Mangement] > [Registor Dept.ID/Password] > [Page
> [System Settings] > [System Maneger Settings] is selected and
[System Maneger ID] and [System Password] are registered, 'Registration
of card to the device' is impossible to execute in the setting of iWAM.
[1]
F-2-82
[1] Document Tray
[2]* Stepped Screw (M4X31)
[3] Stepped Screw (M4X33)
* Not used with this host machine.
F-2-83
[2] [3]
1 pc.
2 pc.
2 pc.
[1]
0015-4777
0015-4778