Checking Of Charging Assembly And Dustproof Glass - Canon imageRUNNER 5065 series Service Manual

[1]
3) Remove the separation claw release member [1] and tag [2] attached onto
the fixing/feeder assembly.
Make sure to remove the foreign particles, such as tape glue, from the
surface of the feeder belt.
[2]
4) Peel off the tag tape to open the fixing/delivery assembly [1].
[1]
5) Remove the 2 fixing nip pressure release screws [1].
[2]
F-2-15
[1]
F-2-16
F-2-17
[1]
[1]
6) Close the fixing/delivery assembly.
2.2.5 Checking of Charging Assembly and Dustproof
Glass
iR5065 / iR 5055 / iR5075 / / /
1) Detach the feeder assembly front cover (right) [1].
- 2 screws [2]
[2]
[1]
2) Remove the screw [1] and the mount [2], and disconnect the connector [3].
[2] [1]
3) While holding the front and rear sides of the transfer/separation charging
assembly [1], slide it in the [A] direction; then, remove it toward the [B]
direction.
Be careful not to cut the nylon wire by contacting the transfer/separation
charging assembly with the transfer guide.
Chapter 2
F-2-18
[2]
F-2-19
[3]
F-2-20
0015-4660
2-7