Canon imageRUNNER 5065 series Service Manual page 533

Sub-item Description
SVMD-ENT Use it to see how to start service mode:
setting
0: User Mode key -> 2 and 8 keys at the same time -> User Mode key (default)
1: User Mode key -> 4 and 9 keys at the same time -> User Mode key
SSH-SW Use it to enable/disable the SSH server function.
Setting
0: off (default)
1: on
RMT-LGIN Use it to turning the SSH server function ON or OFF.
Setting
0: off (default)
1: on
RE-PKEY Use it to enable/disable regeneration of the SSH server key.
setting
0: off (default)
1: on
U-NAME Use it to set user names permitting connection to the SSH server.
setting
8 characters max. (alphanumeric)
U-PASWD Use it to set user passwords permitting connection to the SSH server.
setting
8 characters max. (alphanumeric)
DA-PORT Use it to enable/disable the port for TOT asynchronous status communication.
setting
0: close (default)
1: open (w/ DA installed)
DA-CNCT Use it to set the DA.
setting
0: off (default)
1: on
CHNG-STS Use it to set the TOT status connection port number.
setting
1 to 65535 (default: 20010)
CHNG-CMD Use it to set the TOT command connection port number.
setting
1 to 65535 (default: 20000)
MEAP-DSP Use it to enable/disable a shift from the MEAP to native screen.
setting
0: off (shift to native seen; default)
1: on (do not shift to native screen)
ANIM-SW Use it to enable/disable display of the Error/Jam screen with a MEAP application in operation.
setting
0: off (display warning screen; default)
1: on (do not display warning screen)
MEAP-SSL Use it to set the HTTPS port for MEAP.
setting
0 to 65535 (default: 8443)
STNBY-TM Use it to switch over the standby shift time.
setting
0: normal (default)
1: increase standby shift time until possibility of image distortion is absent
KSIZE-SW Use it to enable/disable support of K paper.
setting
0: do not support K paper (default)
1: support K paper
procedure
1) Set '0' in this service mode.
2) Set '0' for the following: COPIER > OPTION > BODY > MODEL-SZ.
3) Perform the shut-down sequence, and turn off and then on the main power.
POST-DWN A countermeasure mode to prevent smudges from appearing on the lead edge of an image (caused by pre-transfer upper guide) in
the HH environment
Decrease the post high pressure output value from 280uA to 70uA only in the HH environment, as an individual countermeasure,
in order to prevent smudges from appearing on the lead edge of an image caused by the pre-transfer upper guide.
0: Normal (default)
1: Countermeasure mode (A post high pressure value is automatically changed when an HH environment is detected by the
environment sensor.)
IMP-MISS Set OFF/ON for detection of "unmatched" error in the number of printouts.
Setting value:
0: OFF [default]
1: ON
UI-PRINT Control the display of a print job screen on the control panel.
Use this mode to set whether or not to display a print job screen on the control panel.
This mode is available for a user who does not want to display a print job screen on the control panel.
Setting range:
0: Do not display the screen.
1: Display the screen.[default]
COPIER > OPTION > BODY
Chapter 17
Level
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
2
17-37