Canon imageRUNNER 5065 series Service Manual page 83

10) In case that the cable [1] is loose, insert the cable clamp [2] to the frame's hole to fix the cable in place.
11) By reversing the steps used to remove, attach the copyboard glass and the glass retainer.
12) Close the DADF.
13) Shift the cassette heater switch [1] and the environment switch [2] to the on position.
F-2-96
Tighten the screw [3] while pushing on the lens heater [1] in the direction
of the emboss [2]. Be sure that the heater's claw [4] must not be disengaged
when performing this operation. Also check that the bottom of the heater
must not be off from the board.
F-2-97
[1]
F-2-98
[2]
[4]
[3]
[1]
[2]
Chapter 2
2-27