Adjusting The Position Of The Left Deck Pickup Solenoid - Canon imageRUNNER 5065 series Service Manual

Chapter 14
14.8.9 Adjusting the Position of the Left Deck Pickup
Solenoid
iR5065 / iR 5055 / iR5075 / / /
Before removing the left deck pickup solenoid from the support plate [1],
take note of its position with reference to the fixing screw [2] of the solenoid.
Or, mark the position for the solenoid by drawing a line on the support plate
with a scriber.
When mounting the solenoid on its own, be sure to secure it in its original
position.
[2]
14.8.10 Mounting the Reversing Flapper Solenoid
iR5065 / iR 5055 / iR5075 / / /
Before removing the screw, make sure to mark the line in the following step.
1) Adjust the position of the solenoid using the 2 screws [1] so that the driver
lever [2] is pushed fully when the solenoid is on (i.e., when the plunger is
down)
14.8.11 Attaching the Side Guide Timing Belt in the
Manual Feed Tray Assembly
iR5065 / iR 5055 / iR5075 / / /
1) Butt the rack plate [1] of the manual feed tray against section A (open
state).
2) Move the slide volume in the direction of B, and attach the timing belt [2]
onto the pulley [3].
14-24
[A]
57.2 0.5mm
F-14-70
[1]
F-14-71
[1]
[2]
F-14-72
14.8.12 Adjusting the Position of the Lifter Motor M20/M21
of the Cassette 3/4
0015-5329
iR5065 / iR 5055 / iR5075 / / /
1) Remove the cable from the wire saddle, and detach the guide plate [3].
- 1 connector [1]
- 3 screws [2]
[2]
2) While keeping the lifter motor M21/M21 [1] to the right side, tighten the
0016-0027
screw [2] temporally.
3) Set the cassette 3/4 in the machine without paper.
4) Check to make sure the lifer drive guar [1] is engaged with the lifter motor
guar [2] from the right side of the machine.
5) Check to make sure the lifter drive guar is fully away from the lifter motor
guar when the release button of the cassette 3/4 [3] is pressed halfway.
The condition of "pressing released button halfway" is following.
- Separation roller should move down.
- The cassette roller is about to slide out.
0015-5331
6) If the lifter drive guar is not away from the lifter motor, move the position
of the lifter motor M20/M21 [1] to the left and check again with keeping
the release button of the cassette 3/4 pressed halfway.
[2] [1]
B
[3] A
F-14-73
[2]
[3]
[1]
F-14-74
[1]
[2]
F-14-75
[1]
[2]
[2]
F-14-76
0016-0030