Fixing Cleaning Belt; Before Removing The Fixing Web; Removing The Fixing Web; Cleaning The Fixing Oil Dish And The Fixing Cleaning Belt Guide - Canon imageRUNNER 5065 series Service Manual

9.5.11 Fixing Cleaning Belt

9.5.11.1 Before Removing the Fixing Web

iR5065 / iR 5055 / iR5075 / / /
1) Detach the duplexing
12)Reference[Removing the Duplexing Feed Front Cover]
2) Slide out the fixing/feeding unit. (page 9-18)Reference[Removing the
Fixing/Feeding unit]
3) Detach the fixing upper cover. (page 10-13)Reference[Removing the
Fixing Upper Cover]

9.5.11.2 Removing the Fixing Web

iR5065 / iR 5055 / iR5075 / / /
1) Open the web unit [2].
- 2 screws [1]
2) While pushing the web feed roller [1] and the web take-up roller [2]
toward the rear side, detach the fixing web [3].
[3]
9.5.11.3 Cleaning the fixing oil dish and the fixing
cleaning belt guide
iR5065 / iR 5055 / iR5075 / / /
1) Detach the fixing web.
2) Clean the surface of the silicone oil tray [1].
3) Clean the surface of the fixing cleaning web guide [2].
feed front cover. (page
[1]
[2]
F-9-97
[2] [1]
F-9-98
0015-8279
10-
0015-5061

9.5.11.4 Mounting the Fixing Web

iR5065 / iR 5055 / iR5075 / / /
Reverse the removal steps above and follow them to mount the fixing web.
1) Wind the web [2] around the web take-up roller [1] for 2 to 3 times. Make
sure the arm guide plate [3] facing the outside of the web take-up roller
when mounting. Also make sure the oil impregnated in the contact area
of the roller.
When winding the web, make sure the fixing web not skewed or free from
slack [A] or wrinkles.
0016-0087
[A]
Follow the orientation shown in the figure below when winding and mount-
ing the fixing web.
[2]
[1]
F-9-99
[3]
[1]
[2]
F-9-100
F-9-101
Chapter 9
0015-5062
9-31