Verifying Management Ethernet Interface Configuration - Cisco NCS 5500 Series Configuration Manual

Advanced Configuration and Modification of the Management Ethernet Interface
Example:
RP/0/RP0/CPU0:router(config-if)# end
or
RP/0/RP0/CPU0:router(config-if)# commit
Saves configuration changes.
• When you issue the end command, the system prompts you to commit changes:
Uncommitted changes found, commit them before exiting(yes/no/cancel)?
[cancel]:
• Entering yes saves configuration changes to the running configuration file, exits the configuration session, and
returns the router to EXEC mode.
• Entering no exits the configuration session and returns the router to EXEC mode without committing the configuration
changes.
• Entering cancel leaves the router in the current configuration session without exiting or committing the configuration
changes.
• Use the commit command to save the configuration changes to the running configuration file and remain within
the configuration session.

Verifying Management Ethernet Interface Configuration

Perform this task to verify configuration modifications on the Management Ethernet interfaces.
SUMMARY STEPS
1. show interfaces MgmtEth interface-path-id
2. show running-config interface MgmtEth interface-path-id
DETAILED STEPS
Step 1 show interfaces MgmtEth interface-path-id
Example:
RP/0/RP0/CPU0:router# show interfaces MgmtEth 0/RP0/CPU0/0
Displays the Management Ethernet interface configuration.
Step 2 show running-config interface MgmtEth interface-path-id
Interface and Hardware Component Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release 6.1.x
Verifying Management Ethernet Interface Configuration
15