Configuring A Layer 2 Vpn Ac: Example; Configuring Lldp: Examples; Where To Go Next; Additional References - Cisco 6000 Series Configuration Manual

Configuring Ethernet Interfaces
RP/0/RP0/CPU0:router(config-if)# exit
RP/0/RP0/CPU0:router(config)# exit

Configuring a Layer 2 VPN AC: Example

This example indicates how to configure a Layer 2 VPN AC on an Ethernet interface:
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# interface TenGigE 0/0/0/2
RP/0/RP0/CPU0:router(config-if)# l2transport
RP/0/RP0/CPU0:router(config-if-l2)# l2protocol
RP/0/RP0/CPU0:router(config-if-l2)# commit

Configuring LLDP: Examples

This example shows how to enable LLDP globally on the router, and modify the default LLDP operational
characteristics:
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# lldp
RP/0/RP0/CPU0:router(config)# lldp holdtime 60
RP/0/RP0/CPU0:router(config)# lldp reinit 4
RP/0/RP0/CPU0:router(config)# lldp timer 60
RP/0/RP0/CPU0:router(config)# commit
This example shows how to disable a specific Gigabit Ethernet interface for LLDP transmission:
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# interface GigabitEthernet 0/2/0/0
RP/0/RP0/CPU0:router(config-if)# lldp
RP/0/RP0/CPU0:router(config-lldp)# transmit disable

Where to Go Next

When you have configured an Ethernet interface, you can configure individual VLAN subinterfaces on that
Ethernet interface.
For information about modifying Ethernet management interfaces for the shelf controller (SC), route processor
(RP), and distributed RP, see the module in this document.
For information about IPv6 see the Implementing Access Lists and Prefix Lists module in the IP Addresses
and Services Configuration Guide .

Additional References

The following sections provide references related to implementing Gigabit, 10-Gigabit, and Fast Ethernet
interfaces.
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
Configuring a Layer 2 VPN AC: Example
tunnel
45