Checking The Running Configuration Settings; Saving The Running Configuration To Nvram; Safely Powering Off The Router - Cisco ASR-920-8S4Z-PD Hardware Installation Manual

Cisco ASR 920-10SZ-PD and Cisco ASR-920-8S4Z-PD Routers Initial Configuration
Step 5
Router# ping vrf Mgmt-intf <tftfp_server_ip >

Checking the Running Configuration Settings

To check the value of the settings you have entered, enter the show running-config command at the Router#
prompt:
Router# show running-config
To review the changes you have made to the configuration use the show startup-config command in the user
EXEC mode to see the changes and copy run-start stored in the NVRAM.

Saving the Running Configuration to NVRAM

To store the configuration or changes to your startup configuration in NVRAM, enter the copy running-config
startup-config command at the prompt:
Router# copy running-config startup-config
Using this command saves the configuration settings that you created in the router using the configuration
mode and the setup facility. If you fail to do this, your configuration will be lost, and will not be available
when you reload the router next.

Safely Powering Off the Router

This section explains how to shut down the router. We recommend that before turning off all power to the
chassis, you issue the reload command. This ensures that the operating system cleans up all the file systems.
After the reload operation is complete, the router can be powered off safely.
To power off the router safely:
Procedure
Step 1 Slip on the ESD-preventive wrist strap included in the accessory kit.
Step 2
Enter the reload command.
Step 3 Confirm the reload command.
Rmcp-6ru-1#reload
Proceed with reload? [confirm]
Aug 17 00:06:47.051 R0/0: %PMAN-5-EXITACTION: Process manager is exiting: prs exit with
reload chassis code
Step 4 After confirming the reload command, wait until the system bootstrap message is displayed before powering
off the system:
System Bootstrap, Version 15.4(3r)S4, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2014 by cisco Systems, Inc.
Current image running: Boot ROM0
Last reset cause: RSP-Board
UEA platform with 2097152 Kbytes of main memory
Cisco ASR 920-10SZ-PD and Cisco ASR-920-8S4Z-PD Aggregation Services Router Hardware Installation Guide
Checking the Running Configuration Settings
65