Configuring The Throughput Level; Perform Other Configuration Tasks; After Installation - Cisco ASR 1000 Series Quick Start Manual

Configuring the Throughput Level

You can upgrade the traffic throughput level by activating the right-to-use license. For more information on the right-to-use
license activation, see Configuring Cisco Right-To-Use License Configuration
throughput level, run the show platform hardware throughput level command. The following example shows the output of this
command before the performance upgrade license is applied:
Router# show platform hardware throughput level
The current throughput level is 4000000 kb/s
To configure the throughput level
To upgrade the throughput level use the platform hardware throughput level {1000000 | 2000000 | 4000000 | 5000000}
command
Step 1 In the user EXEC configuration mode, enter the enable command.
Enter configure terminal command to enter the global configuration mode .
Step 2
To upgrade the throughput level enter the platform hardware throughput level {1000000 | 2000000 | 4000000 |
Step 3
5000000} command.
Step 4 To exit global configuration mode enter exit
Step 5 To save the configuration, enter the copy running-config startup-config command.
To reload the router enter reload. A reload is required to activate the throughput level.
Step 6
The following example shows how to upgrade the throughput level:
Router>enable
Router#configure terminal
Router(config)#platform hardware throughput level 5000000
% The config will take effect on next reboot
Router(config)#exit
Router#copy running-config startup-config
Router#reload

Perform Other Configuration Tasks

To make advanced configuration changes after you establish the basic startup configuration for your router, refer to the Cisco
ASR 1000 Series Aggregation Services Routers Software Configuration Guide and modular configuration and modular
command reference publications in the Cisco IOS software configuration documentation set that corresponds to the software
release installed on your Cisco hardware. These publications contain additional information on using the configure command.
The configuration publications also provide information about the following tasks:
• Understanding command modes
• Booting and rebooting the router
• Understanding software packages and architecture for the Cisco ASR 1002-X Router
• Software Upgrades
7

After Installation

Follow the instructions in this section to replace field-replaceable units (FRUs) after installation. The Cisco ASR 1002-X Router
supports the following components as FRUs: Cisco ASR1000-ESP5, shared port adapters, and power supplies.
Note For a complete list of Cisco ASR 1000 Series Routers field replaceable units, see
Services Routers Hardware Installation
36
perform the steps detailed in this section.
Guide.
Guide. If you want to determine the current
Cisco ASR 1000 Series Aggregation