Monitoring Per-Port Interface Statistics; Configuration Examples - Cisco ASR 1000 Configuration Manual

Configuration Examples

Monitoring Per-Port Interface Statistics

Use the show controllers atm command to display detailed status and statistical information on a
per-port basis for an ATM SPA. The following example provides sample output for interface port 2 on
the ATM SPA that is located in subslot 2 of the SIP that is installed in slot 0 of a Cisco ASR 1000 Series
Router:
Router# show controllers atm 0/2/2
Interface ATM0/2/2 (SPA-3XOC3-ATM-V2[0/2]) is up
Framing mode: SONET OC3 STS-3c
SONET Subblock:
SECTION
LOF = 0
LINE
AIS = 0
PATH
AIS = 0
LOP = 1
Active Defects: None
Active Alarms:
Alarm reporting enabled for: SF SLOS SLOF B1-TCA B2-TCA PLOP B3-TCA
ATM framing errors:
HCS (correctable):
HCS (uncorrectable): 0
APS
not configured
COAPS = 0
State: PSBF_state = False
Rx(K1/K2): 00/00
Rx Synchronization Status S1 = 00
S1S0 = 00, C2 = 13
PATH TRACE BUFFER : STABLE
BER thresholds:
TCA thresholds:
Clock source:
Configuration Examples
This section includes the following configuration examples for the ATM SPAs:
•
•
•
•
•
•
•
•
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
7-28
LOS = 1
RDI = 1
RDI = 1
NEWPTR = 0
None
0
PSBF = 0
Tx(K1/K2): 00/00
SF = 10e-3
B1 = 10e-6
line
Basic Interface Configuration Example, page 7-29
MTU Configuration Example, page 7-29
PVC on a Point-to-Point Subinterface Configuration Example, page 7-29
PVC Ranges on a Multipoint Subinterface for PPPoEoA Configuration Example, page 7-30
PVC Ranges on a Multipoint Subinterface for PPPoEoA Configuration Example, page 7-30
AToM VP Cell Mode Relay Configuration Example, page 7-30
PPPoEoA VC Class and PVC Range Configuration Example, page 7-30
SONET and SDH Framing Configuration Example, page 7-31
FEBE = 55
FEBE = 21
PSE = 0
SD = 10e-6
B2 = 10e-6 B3 = 10e-6
Chapter 7 Configuring the ATM SPAs
BIP(B1) = 0
BIP(B2) = 0
BIP(B3) = 0
NSE = 0
OL-14127-08