Omron NX-SL3300 User Manual page 187

The Connection Settings (Originator) Tab Page consists of the items shown in the following ta-
ble.
Item
EtherNet/IP Port 1
EtherNet/IP Port 2
Target Device
In/Out
Target I/O Assembly
Active
EPI [ms]
Network Reaction Time [ms]
Instance name
Go To I/O Map Button
Device Bandwidth Button
NX-series Safety Control Unit User's Manual (Z930)
Settings of CIP Safety connections via the built-in EtherNet/IP port 1 are list-
ed.
Safety Network Number: Specifies the SNN for the EtherNet/IP network for
which the port 1 is connected
Connection list: Connections grouped together by each target device are list-
ed.
Settings of CIP Safety connections via the built-in EtherNet/IP port 2 are list-
ed.
Safety Network Number: Specifies the SNN for the EtherNet/IP network for
which the port 2 is connected
Connection list: Connections grouped together by each target device are list-
ed.
IP address, Unit number, and device name are displayed for the target device
with which a CIP Safety connection is to be opened.
Shows the data direction of each connection.
: In - Data to be received from the target device
: Out - Data to be sent to the target device
I/O Assembly name of the target device with which a connection is to be
opened is displayed.
Enable/disable each connection.
Selected: Connection is active.
Not selected: Connection is inactive.
Specifies the Expected Packet Interval (data update cycle) in ms.
Displays the value of the Network Reaction Time in ms. This is used in calcu-
lating the safety reaction time.
Name of the instance being managed in the program. Connection status can
be checked if the connection is registered in the Watch Tab Page.
Click this button to open the I/O Map Tab Page.
Click this button to show bandwidth usage of originator connection.
5 System Configuration and Setup
Description
5
5 - 15