Omron NX-SL3300 User Manual page 327

Nx series safety control unit

Hide thumbs Also See for NX-SL3300:

Table of Contents

l When Sysmac Studio Is Connected to Communications Coupler Unit

Place the Sysmac Studio online with the Communications Coupler Unit.

Place the Sysmac Studio online with the Communications Coupler Unit that the Safety CPU

Unit is connected to. The following procedure cannot be executed on a Communications Cou-

pler Unit that the Safety CPU Unit is not connected to.

Place the Safety CPU Unit in DEBUG mode.

Refer to 7-4 Changing to DEBUG Mode on page 7 - 17 for a detailed procedure.

Double-click Parameters under the name of the Safety I/O Unit under Configurations and

Setup − Communications − Safety − Safety I/O.

The Parameters Tab Page shown below is displayed. Select the Safety I/O Unit to monitor.

NX-series Safety Control Unit User's Manual (Z930)

7 Checking Operation and Actual Operation

Troubleshooting