Omron NX-SL3300 User Manual page 123

Connecting and Removing Wires
This section describes how to connect and remove wires.
l Terminal Block Parts and Names
l Required Tools
Use a flat-blade screwdriver to connect and remove wires.
Use the following flat-blade screwdriver.
Side view
8° to 12°
0.4 mm
Recommended screwdriver
Model
SZF 0-0,4X2,5 Phoenix Contact
l Connecting Ferrules
Insert the ferrule straight into the terminal hole.
You do not need to insert a flat-blade screwdriver into the release hole.
After you make a connection, make sure that the ferrule is securely connected to the terminal
block.
NX-series Safety Control Unit User's Manual (Z930)
Release hole
Terminal hole
Front view
2.5-mm dia.
2.5 mm
Manufacturer
Ferrule
3 Installation and Wiring
3 - 15
3