Omron NX-SL3300 User Manual page 312

7 Checking Operation and Actual Operation
•
When you transfer the data through the NJ/NX-series CPU Unit without using the Sysmac Studio's syn-
chronization operation.
•
When you transfer the data with the Sysmac Studio connected to the USB port on the Communications
Coupler Unit
The restart may cause the EtherCAT master to detect an error. If an error is detected, you need to reset the
error in the EtherCAT master.
*3. Supported only by Sysmac Studio version 1.10 or higher.
Version Information
You can download safety-validated safety application data with Sysmac Studio version 1.10 or
higher and NX-SL££££ version 1.1 or later.
7 - 6
NX-series Safety Control Unit User's Manual (Z930)