3 Installation and Wiring
l Connecting Twisted Wires/Solid Wires
Use the following procedure to connect the twisted wires or solid wires to the terminal block.
1
Press the flat-blade screwdriver diagonally into the release hole.
The optimal angle for insertion is between 10° to 15°. If you press in the screwdriver correctly,
you will feel the spring in the release hole.
2
Leave the flat-blade screwdriver pressed into the release hole and insert the twisted wire or the
solid wire into the terminal hole.
Insert the twisted wire or the solid wire until the stripped portion is no longer visible to prevent
shorting.
3
Remove the flat-blade screwdriver from the release hole.
After you make a connection, make sure that the twisted wire or the solid wire is securely connect-
ed to the terminal block.
3 - 16
Release hole
2
Twisted wire or Solid wire
3
Flat-blade screwdriver
NX-series Safety Control Unit User's Manual (Z930)
1
10° to 15°