Omron NX-SL3300 User Manual page 597

Nx series safety control unit

Hide thumbs Also See for NX-SL3300:

Table of Contents

NX-series Safety Control Unit User's Manual (Z930)

Either the segment is not present or the encoded value in the network segment is

Link address to self is invalid.

Resources on secondary are unavailable.

Connection is already established.

Direct connection is already established.

Redundant connection mismatch.

There are no more reception resources available on the sending module.

No connection resources exist for the target path.

Vendor specific.

Incompatible Multicast RPI. An existing connection has been established at a dif-

Invalid Safety Connection Size

Invalid Safety Connection Format

Invalid Time Correction Connection Parameters

Invalid Ping Interval EPI Multiplier

Time Coordination Msg Min Multiplier

Network Time Expectation Multiplier

Timeout Multiplier

Invalid Max Consumer Number

Invalid CPCRC

Time Correction Connection Id Invalid

SCID Mismatch. The SCID was non-zero and did not match the value in the tar-

TUNID not set. Device is out-of-box and TUNID has not been set, so connections

are not allowed.

TUNID Mismatch. The TUNID provided does not match. The message was likely

routed to this node in error

Configuration operation not allowed

No target application data available

No originator application data available

Node address has changed since the network was scheduled

Not configured for off-subnet multicast

Invalid Produce/Consume Data Format

Troubleshooting