Omron NX-SL3300 User Manual page 52

1 Overview
Achieving Standalone Safety Control System on EtherNet/IP Slave
Terminal
l Constructing a Small Safety Control System
You can configure a small standalone safety control system on the EtherNet/IP Slave Terminal by
using an NX-series Safety Control Unit.
l Easy Creation of an Interface with the Standard I/O Data
You can easily exchange data between Safety CPU Unit and standard I/O Units.
Excellent Connectability with OMRON Safety I/O Devices
You can directly connect OMRON's wide lineup of Safety I/O Devices to Safety I/O Units without using
any special units.
Integrating Setting and Debugging Operations for Safety Controls
into the Sysmac Studio
Setting and debugging operations for safety controls are integrated into the Sysmac Studio Automa-
tion Software.
The shared concepts, such as IEC 61131-3, consistent operating procedures, one-project manage-
ment, integrated debugging, and integrated troubleshooting, reduce the software workload.
Support for the IEC 61131-3 Programming Environment
l Program Languages Based on the IEC 61131-3 International Standard
Programming is possible with the FBD language, which is part of the programming language speci-
fications of IEC 61131-3. And the safety function blocks that are defined in PLCopen® TC5 Safety
are also supported.
l Programming with Variables
Programming with variables eliminates the need to specify memory addresses so that you can cre-
ate user programs that are not dependent on any hardware considerations, such as the model of
the Controller or the system configuration. This allows you to reuse user programming, even for dif-
ferent Controller models or system configurations.
Complete Advanced Validation
1 - 6
NX-series Safety Control Unit User's Manual (Z930)