Omron NX-SL3300 User Manual page 466

12 Troubleshooting
Event name Cast Error
Meaning A casting error was detected.
Source Depends on where the Sysmac
Studio is connected and the sys-
tem configuration.
Error attrib- Level
utes
Effects User program
System-de- Variable
fined varia-
None
bles
Cause and Assumed cause
correction
A value was input that exceeded
the range of the receiving varia-
ble.
Attached in- Attached infor-
formation mation 1:
Precautions/ The CPU Unit executes NX bus communications but execution of the user program stops. (All I/O data
Remarks will remain at 0.)
12 - 54
Source details NX Unit
Minor fault Recovery
Continues. Operation
Data type
None
Correction
Do not allow the value to exceed
the range of the receiving varia-
ble.
Perform the following corrections
according to the operating mode
of the Safety CPU Unit.
•
RUN mode: Change to PRO-
GRAM mode and transfer the
corrected user program.
•
DEBUG mode (RUN): Change
to PROGRAM mode and
transfer the corrected user
program.
Error details
0x01000ADF: The conversion between the signed and unsigned data types was failed.
0x01000AE0: The positive upper limit of the data type after conversion was exceeded.
0x01000AE1: The negative upper limit of the data type after conversion was exceed-
ed.
Event code 55010000 hex
Detection tim-
ing
Automatic re- Log category
covery
The CPU Unit executes NX bus communications
but execution of the user program stops. (All I/O
data will remain at 0.)
Name
None
Prevention
Program operation considering
the corrections that are given on
the left.
NX-series Safety Control Unit User's Manual (Z930)
In DEBUG
mode (RUN) or
RUN mode
System