Omron NX-SL3300 User Manual page 119

l Using Ferrules
If you use ferrules, attach the twisted wires to them.
Observe the application instructions for your ferrules for the wire stripping length when attaching
ferrules.
Precautions for Correct Use
Always use plated one-pin ferrules. Do not use unplated ferrules or two-pin ferrules.
The applicable ferrules, wires, and crimping tools are given in the following table.
Termi- Manufac-
nal type
All ter- Phoenix
minals Contact
except
ground
termi-
nals
Ground
termi-
nals
All ter- Weidmuller
minals
except
ground
termi-
nals
*1.
Some AWG14 wires exceed 2.0 mm
When you use any ferrules other than those in the above table, crimp them to the twisted wires so
that the following processed dimensions are achieved.
NX-series Safety Control Unit User's Manual (Z930)
Applicable
Ferrule
turer model
(mm
AI0,34-8 0.34 (#22)
AI0,5-8 0.5 (#20)
AI0,5-10
AI0,75-8 0.75 (#18)
AI0,75-10
AI1,0-8 1.0 (#18)
AI1,0-10
AI1,5-8 1.5 (#16)
AI1,5-10
AI2,5-10
*1
2.0
H0.14/12 0.14 (#26)
H0.25/12 0.25 (#24)
H0.34/12 0.34 (#22)
H0.5/14 0.5 (#20)
H0.5/16
H0.75/14 0.75 (#18)
H0.75/16
H1.0/14 1.0 (#18)
H1.0/16
H1.5/14 1.5 (#16)
H1.5/16
2
wire
2
(AWG))
Phoenix Contact (Applicable wire sizes are given in
parentheses.)
CRIMPFOX 6 (0.25 to 6 mm
Weidmuller (Applicable wire sizes are given in pa-
rentheses.)
PZ6 Roto (0.14 to 6 mm
and cannot be used in the screwless clamping terminal block.
3 Installation and Wiring
Crimping tool
2
, AWG24 to 10)
2
, AWG26 to 10)
3 - 11
3