2
Select the NJ/NX-series CPU Unit from the Controller Selection Box in the Multiview Explorer
on the Sysmac Studio to change to the NJ/NX-series CPU Unit Setup and Programming View.
3
Right-click the EtherCAT Coupler Unit on the EtherCAT Slave Terminal Tab Page, and select
Coupler Connection (USB) − Online from the menu.
The Sysmac Studio goes online with the EtherCAT Slave Terminal.
l Online Procedure from the Safety CPU Unit Setup and Programming View
1
Connect the computer to the Communications Coupler Unit with a USB cable.
2
Select Safety CPU Unit from the Controller Selection Box in the Multiview Explorer of Sysmac
Studio and open the Safety CPU Unit Setup and Programming View.
3
Select Communication Setup from the Controller Menu.
The following communications settings are displayed.
4
Select Connect via Coupler and then click the OK Button.
5
Select Online from the Controller Menu. Or, click the Go Online Button (
The Sysmac Studio goes online with the Slave Terminal.
l Procedure to Transfer the Configuration Information
Use the following procedure to transfer the configuration information to an online Slave Terminal.
1
Right-click the Communications Coupler Unit on the Slave Terminal Tab Page, and select
Transfer to Coupler from the menu.
The following dialog box is displayed.
NX-series Safety Control Unit User's Manual (Z930)
7 Checking Operation and Actual Operation
7
) in the toolbar.
7 - 9