Table of Contents
Advertisement
®
xStack
Parameter
IP Prefix
Click the Find button to locate a specific entry based on the information entered.
Click the View All button to display all the configure entries.
MPLS Interface Settings
This window enables or disables MPLS on the specified interface.
To view this window, click VPN > MPLS > MPLS Interface Settings as shown below:
The fields that can be configured are described below:
Parameter
IP Interface Name
State
Click the Apply button to accept the changes made.
MPLS Class Map Settings
This window is used to configure the mapping between the EXP and CoS. CoS 7 is reserved for the system.
The following table shows the default mapping between EXP and CoS.
0
EXP
2
CoS
To view this window, click VPN > MPLS > MPLS Class Map Settings as shown below:
The fields that can be configured are described below:
Parameter
EXP (0-7)
DES-3810 Series Layer 3 Managed Ethernet Switch Web UI Reference Guide
Description
Enter the IP prefix FEC address of the LSP here.
Figure 4-21 MPLS Interface Settings window
Description
Enter the IP interface name used here. This name can be up to 12 characters long.
Enabled or disabled the MPLS IP interface. By default, the state is disabled on all
interfaces.
1
2
0
1
Figure 4-22 MPLS Class Map Settings window
Description
Enter the EXP value, that will be mapped to the CoS, here. This value must be between 0
and 7.
3
4
3
4
66
5
6
5
6
7
6
Advertisement
Table of Contents
