Omron K6CM User Manual page 45

Nomenclature and Functions of the Front Panel of the K6CM Device
Push-In Plus terminals (*1)
• K6CM device power supply
• External trigger input
LCD display for numerical value
such as measured value
Status
display
Product status
indication
Network status
indication
EtherNet/IP port
Name
Alarm bar display The LED bar emits light according to the state
of the comprehensive alarm (above the mea-
surement value).
Unit of measurement The unit of the measurement value (monitor-
value (monitoring cate- ing category) is indicated by the following
gory) LCD characters.
Press the [DISP] key to switch the display.
Types of measurement When the K6CM device is being measured
such as present value, and monitored, LCD character shown in the
minimum value, and max- right column indicates whether the measure-
imum value ment value displayed on the LCD is the pres-
ent value, the minimum value, or the
maximum value.
Note : To switch between the values shown
K6CM Motor Condition Monitoring Device User's Manual (N219)
in the right column as measurement
values, use the "Display value selec-
tion" setting from the host, followed
by a power cycle or a software reset
(depending on the Motor condition
monitoring Tool or EtherNet/IP. It is
not switchable by front operation).
2 Nomenclature and Functions
DIN Track hook
Push-In Plus terminals (*1)
• Sensor input
Alarm bar display
Unit of measurement value
(monitoring category)
Types of measurement such
as current value, minimum value,
and maximum value
[ARM RST] Key
[DISP] Key
Push-In Plus terminals (*1)
• Transistor Output
*1. Refer to "Push-In Plus terminals
layout" described below.
Meaning
During measuring and monitoring, the following colors are
used.
• Comprehensive alarm (normal): green
• Comprehensive alarm (Warning): Yellow
• Comprehensive alarm (Critical): Red
Note : The above LCD color is retained after measuring and
monitoring.
Turns OFF when one of the following occurs:
when the power is OFF, when measuring and monitoring is
not started yet, when self-diagnos error occurs.
• "G": Acceleration, "mm/s": Velocity, "T": Motor temperature
"∆T": Temperature gap (Difference from room temperature
to room temperature) (Vibration & temperature type)
• "MΩ": Insulation resistance, "mA": Leakage current (Insula-
tion resistance type)
• "A": current (Comprehensive current diagnostic type)
• "Cim": degree of degradation (Comprehensive current diag-
nostic type)
• "PV": present value
• "MIN": minimum value
• "MAX": maximum value
The minimum and maximum values indicate the current mini-
mum and maximum values in one measuring and monitoring
period.
The display is updated each time the minimum and maximum
values are updated. Both are retained at the end of measuring
and monitoring, but will be reset the next time the power is
turned ON again.
Front operating part
2 - 3
2