Motor Condition Monitoring Tool Ip Address Settings On The Computer Side Before Starting - Omron K6CM User Manual

5-2-4 Motor condition monitoring Tool IP Address Settings on the
Computer Side Before Starting
Before starting this tool and monitoring and logging the K6CM device, it is necessary to set the IP
address of the computer to the IP address of the same segment as the K6CM device. It shows the pro-
cedure.
Note that when setting only the K6CM device (IP address and other settings), it is not necessary to set
the IP address on the computer side.
For the initial setting of K6CM, refer to "5-4 Initial Setting of K6CM Devices on page 5-35"
• Windows 7
1
Select [Start] | [Control Panel] | [Network and Sharing Center] | [Change Adapter Settings].
2
Right-click [Loca Area Connection] and select [Properties].
3
Select [Internet Protocol Version 4 (TCP / IPv4)] and click [Properties].
Check "Use next IP address" and manually set the IP address of the computer.
• Windows 8.1
1
Right-click [Start].
2
Select [Network connection].
3
Right-click [Ethernet], and click [Properties].
4
Select [Internet Protocol Version 4 (TCP / IPv4)] and click [Properties].
Check "Use next IP address" and manually set the IP address of the computer.
• Windows 10
1
Click [Start] and select [Windows System Tools] | [Control Panel].
2
Select [Network and Sharing Center] | [Change adapter settings].
3
Right-click Ethernet and click Properties.
4
Select [Internet Protocol Version 4 (TCP/IPv4)] and click [Properties].
Check "Use next IP address" and manually set the IP address of the computer.
K6CM Motor Condition Monitoring Device User's Manual (N219)
5 Setting with the Motor condition monitoring Tool
5
5 - 19